DieHard 71341 Manuel du propriétaire télécharger pdf (Page 10)

• 10 •

ERROR

CODE

DESCRIPTION REASON/SOLUTION

F06

The charger detected that the

battery may be getting too hot

(thermal runaway).

The charger automatically shuts the current off if

it detects the battery may be getting too hot. Have

the battery checked or replaced.

If you get an error code, check the connections and settings and/or replace the battery.

Troubleshooting

PROBLEM POSSIBLE CAUSE REASON/SOLUTION

Charger will not turn

on when properly

connected.

AC outlet is dead.

Poor electrical connection.

Battery is defective.

Check for open fuse or circuit

breaker supplying AC outlet.

Check power cord and extension

cord for loose tting plug.

Have the battery checked.

Three LEDs come on for

2 seconds, then turn off.

The charger is plugged into an

AC outlet.

No problem; this is normal.

Engine start does

not work.

Drawing more than 250 amps.

Failure to wait 3 minutes (180

seconds) between cranks.

The charger may be

overheated.

Battery may be severely

discharged.

Crank time varies with the

amount of current drawn. If

cranking draws more than 250

amps, crank time may be less

than 5 seconds.

When the Engine Start LED

blinks, wait 3 minutes of rest time

before the next crank.

The thermal protector may have

tripped and needs a little longer

to reset. Make sure the charger

vents are not blocked. Wait and

try again.

On a severely discharged battery,

use the 40A Boost rate for 10 to 15

minutes, to help assist in cranking.

The Boost LED is

ashing.

The charger was left in Boost

mode for an extended period

of time.

The Boost LED will ash for 30

minutes, then go off, and the

Charging LED will light, indicating

the charger has switched to

Charging mode.

14. BEFORE RETURNING FOR REPAIRS

•When a charging problem arises, make

certain that the battery is capable of

accepting a normal charge. Double check

all connections, the AC outlet for a full

120 volts, the charger clamps for correct

polarity and the quality of the connections

from the cables to the clamps and from

the clamps to the battery system. The

clamps must be clean.

•When an UNKNOWN OPERATING

PROBLEM arises, please read the

complete manual and call the customer

service number for information. This will

usually eliminate the need for return.

If the above solutions do not eliminate the problem,

or for information about troubleshooting or replacement parts,

call toll-free from anywhere in the U.S.A.

1-800-732-7764

7:00 am to 5:00 pm CT, Monday through Friday

1 2 3 4 5 6 7 8 9 10

Commentaires sur ces manuels

Pas de commentaire

DieHard 71341 Manuel du propriétaire Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Chargeurs de batterie DieHard 71341